FLOOR MODEL GAS DECK OVEN SERVICE MANUAL
14
GAS CONVERSION
Conversion kits shall be installed by a qualified
service agency in accordance with the
manufacturer’s instructions and all applicable
codes and requirements of the authority having
jurisdiction. If the information in these
instructions is not followed exactly, a fire, an
explosion or production of carbon monoxide
may result causing property damage, personal
injury or loss of life. The qualified service
agency is responsible for the proper installation
of this kit. The installation is not proper
and complete until the operation of the converted
appliance is checked as specified in the
manufacturer’s instructions.
WARNING
There are times it is required to do a field conversion
from one gas type to another.
Consult with your Technical Service Representative to
order the correct parts for the oven model you will be
converting.
• Shut off the gas to the oven.
• Remove the two screws that hold the regulator in
place on the combination valve. Remove the gasket.
Install a new gasket and the new regulator. Insure
the regulator gasket is in place with two circular
cut-outs over small posts in the valve body casting.
Evenly tighten the two screws holding he regulator
in place. The conversion kit includes a label to be
placed on the side of the valve body to inform others
that the conversion has taken place.
• Remove the orifices from the inspirators. Depending
on the oven model there will be one, two or three
that need to be changed.
• Change the orifice in the pilot.
• Refer to other sections of this manual. Test for gas
leaks.
• Follow normal start-up procedures for lighting and
adjusting the pilot and insuring the gas-air mixture
to the burners is correct.
