3
BAK Thermoplastic Welding Technology AG
WARRANTY AND LIABILTY
Warranty and liability apply from the date of purchase (documented by the
invoice/delivery note) according to the currently valid general terms of business from
BAK. BAK refuses to honour any warranty for devices which are not in their original
condition. BAK devices may never be reconfigured and/or modified.
BAK reserves the right to deny any responsibility if this is ignored. No liability can be
assumed by BAK for incorrect installation and/or use as well as natural wear and tear
of components (e.g. heating elements).
Note:
This operating manual must be available to the installation and operating personnel at
all times. Read these operating instructions carefully before installing and using the
device.
Copyright:
This document must not be disclosed to third parties without the explicit written
approval of BAK. Any forms of reproduction or copying and electronic storage are
prohibited.
INTENDED USE
Welding
thermoplastic material as well as modified bitumen. Sheets, pipes,
profiles, membrane, tarps, foils and floor covers. Following seams are possible:
Overlap-, rod-, but- and melt.
Heating-up
for forming, bending and sealing of thermoplastic semi-finished
material.
Drying
of water-damp surfaces and joints.
Shrinking
of heat-sink sleeves, films, tapes, solder sleeves and moulded parts.
Soldering and desoldering.
Defrosting
of frozen water pipes.
Activating / dissolving
of solvent free adhesives and fusion adhesives.
Igniting
of wood shavings, paper, coal or straw in furnaces.
DEVICE DESCRIPTION
1
Power supply cord
5
Air filter
2
Main switch
6
Rubber stand
3
Potentiometer for temperature adjustment
7
Heater tube
4
Handle
