CHANGING THE OIL
*
1. Remove the “Screw Plug” located at the bottom of the engine and let the oil drain into an
approved collection container. DO NOT PERFORM THIS PROCEDURE WHILE THE ENGINE IS
HOT. SERIOUS BURNS COULD RESULT FROM CONTACT WITH HOT OIL.
2. Dispose of the used oil properly. For proper disposal procedures, contact your local oil
recycling center.
3. Clean and replace the “Screw Plug” tighly.
4. Refill the engine with the proper amount of oil and recheck the amount of oil in the
engine by using the oil gauge plug.
Screw plug for oil draining
CHECk-UP OF SPARk PLUG
1. Remove the cap of spark plug and screw off the spark
plug using the plug wrench.
2. Clean the spark plug all around or replace it if it is
corroded or there is too much deposit on it.
3. Regulate the gap of the spark plug to 0.6-0.7mm (.024”-
.028”).
3. The spark plug of the designated type should be used.
The applicable type of spark plug: NHSP LD A7RTC
made in China or Equivalent US Brand.
0.6~0.7mm
Содержание Dirt Runner 90cc
Страница 17: ...PARTS SUBASSEMBLIES Front brake lever Throttle twist grip Fuel tank cover 11 ...
Страница 18: ...Pièces et sous assememblage Frein à main Poignée de l accélérateur Couvercle du réservoir à essence 12 ...
Страница 62: ...Baja Inc P O Box 61150 Phoenix Az 85082 Tel 602 443 9180 Toll Free 888 863 2252 ...