16
1 800 463.2187
Monday to Thursday from 8 a.m. to 6 p.m. (EST) . Friday from 8 a.m. to 5 p.m. (EST)
Printed in Canada. Copyright © December 2019 BainUltra Inc. All rights reserved. 45200689
BAIN DE VILLE
TM
| INSTALLATION INSTRUCTIONS
TURBINE REMOTE INSTALLATION
SITE PREPARATION
TURBINE REMOTE INSTALLATION
1. A 1 ½ inch ID pipe has to run from the tub, back to the turbine location. This pipe can be PVC Tigerflex (spa hose) or rigid PVC or ABS.
2. Maximum distance is 15 feet from the tub, indoors, in a room temperate setting (not outdoors or in a non-temperature controlled area).
3. The minimum size for the turbine enclosure must be: 16’’ x 16’’ x 16’’.
4. Make sure to leave access for servicing needs.
5. The enclosure should have a minimum 4x2 inch opening so the turbine works properly. Not doing so will starve the turbine of air.
It will eventually fail and void its warranty.
6. A 20 Amp GFCI (12AWG) 120V dedicated line is needed for the turbine (Geysair is powered by the turbine). If you have additional
options on the bath (one or more) a second dedicated line is needed, 15 Amp GFCI 120V (14AWG).
GEYSAIR
®
1. Geysair is installed on the bathtub at the factory and must not be relocated. It gets its power from your turbine. So per your local
electrical code, you may have to use a solid core wire (14AWG) and run it in between the turbine location and the bathtub.
This may require a proper conduit for high voltage wires if installed in a cement slab for example.
2. Geysair is connected to the hot water supply that goes to your bathtub faucet. It uses a 3/8 compression thread.
LED (CHROMATHERAPY)
1. The power modules (inMix module, Litestreme) have to be installed next to the turbine.
2. The wires have to be sent from the tub back to the turbine location.
LED: Low voltage for the Chromatherapy .
For further questions, please contact our
Technical Support
..........................................................................
1 888 763-4444
