INSTALLATION
CABLE INSTALLATION
I-E96-418A
2 - 3
3. Connect the chassis ground by installing a number ten self
tapping screw and external star washer in the location shown
in Figure
CABLE INSTALLATION
Termination Unit Cables
After mounting the termination unit to the FTP, install the ter-
mination cables. Table
lists the termination cables, their
application, connector assignments and length restrictions.
Figure
shows a diagram of cable connections to the LIM
and TPL. To install the termination unit cable:
1. Install the hooded end of the appropriate cable in the Mod-
ule Mounting Unit (MMU) backplane slot assigned to the LIM.
NOTE: If the LIM is installed in its slot, pull the module away from
the MMU backplane several inches. The card edge of the module
must not come into contact with the card edge connector of the ter-
mination cable while installing the cable. After installing both ends of
the cable, slide the module into the MMU so that the card edge sits
within the card edge connector. Refer to the product instruction for
the INLIM03 for more information about the installation or removal of
that module.
2. Insert the socket connector end of the cable into P1 of the
TPL. See Figure
for the location of P1 on the TPL circuit
board.
Table 2-1. TPL Cable Applications
Nomenclature/
Description
Application
Connector
Max Length
Meters (Feet)
NKLM01 (PVC), NKLM02 (non-PVC)
Termination cable
Connects the TPL to
the INLIM03
P1
61 (200)
NKPL01 (PVC), NKPL02 (non-PVC)
Twinaxial communication cable, Plant
Loop
Connect individual
drops on the
communication loop
TB1 and TB2
2000 (6562)
Figure 2-2. TPL Cable Connection to the INLIM03
INLIM03
P3
NKLM01/02
P1
TB2
TB1
COMMON
+24 VDC
NKPL01/02
NKPL01/02
T00599A
NTPL01
+
+
1
+
+
5
–
–
2
–
–
6
1
5
2
6
