TERMINATION UNIT (NTCS04) CONFIGURATION
INTRODUCTION
WBPEEUI240755B0
A - 3
Table A-3. Analog Output Dipshunt Configuration
Application/Signal Type
Dipshunt Configuration XU9
Both outputs in voltage mode
Output 1 in voltage mode, output 2 in
current mode
Output 1 in current mode, output 2 in
voltage mode
Both outputs in current mode (no dip-
shunt required)
Table A-4. Digital Input Dipshunt Configuration
Application/Signal Type
Dipshunt Configuration XU5-XU7
System powered E3/E4
Field powered
1
NOTE:
1. Using the field device to complete the path to ground is commonly referred to as
switching neu-
tral. Using the field device to complete the path to the I/O module is referred to as switching hot.
If switching hot is the desired method, the field powered dipshunt configuration must be used. If
system power is required, it should be wired as a field source. Refer to Figure
for an example
of switching hot and switching neutral.
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
1
2
3
4
5
6
7
8
TP27118A
1
2
3
4
5
6
7
8
