Bailey Caravan, Руководство пользователя

Страница: 81 / 127

4-38
4
Caravan Equipment
pressing the flush button for several seconds (if necessary re-activate the control panel). Close
the blade after use.
▲
If your toilet has its own flush-water tank, please make sure that you do not travel with a
flush-water tank that is too full. Do not travel with water in the toilet bowl. Failure to
adhere to this notice may result in water damage to your caravan or motor home.
4.13.5 Using the toilet with Optional Features
13. Electric Blade: Push the electric blade button on the control display to electrically open or close the
blade. In the case of failure, you can manually open or close the blade by sliding the small handle
under the toilet bowl sideways.
14. Automatic Ventilator: The ventilator automatically starts when the control panel is activated (by
pressing the flush button) and will automatically shut off after approximately 5 minutes. The Automatic
Ventilator Indicator will flash until automatic shut-off occurs. If you want to stop the ventilator, press
the Automatic Ventilator button. If you want to re-start the ventilator, press the button again (the
LED will start flashing again).
15. Flush Water Tank Level Indicator (only for toilets with own flush-water tank): When the Flush
Water Tank Level Indicator lights up, refill the flush-water tank, as only about 1.5 litres of water is
left in the tank, which is sufficient for approximately 2 flushes.
4.13.6 Emptying
The Waste Holding Tank has a capacity of 18 litres and requires emptying when the red light (LED) on
the toilet control display lights up, when the Waste Holding Tank only has capacity for approximately 2
more litres, which is no more than two to three further uses.
Make sure that the blade is closed. Open the access door located outside the vehicle, pull the safety
catch upwards and remove the Waste Holding Tank.
16. Place the Waste Holding Tank in an upright position (Pull-Out Handle at the top, Wheels at the
bottom). Slide the handle sideways - to the front of the tank - until it snaps out of its locked position.
17. Pull the handle up and wheel the Waste Holding Tank to an authorized waste disposal point.
18. Push the handle back into its locked position. Turn the emptying spout upwards and remove the
cap from the spout. Hold the Waste Holding Tank in such a way that during emptying you can
operate the vent plunger with your thumb. To empty the tank without splashing, depress the vent
plunger while emptying the tank. After emptying, rinse the tank and blade thoroughly with water.
▲
Do not seriously shake the tank or use high pressure water cleaners. This may cause
damage to the tank’s interior.
▲
The vent plunger should only be depressed once the emptying spout is pointing
downwards. Prepare the toilet for re-use if required. Slide the Waste Holding Tank into
the toilet and close the access door.
4.13.7 Emptying with Optional Features
19. Waste Holding Tank Multi-Level Indicator: The lower lamp indicates that the Waste Holding Tank is
almost empty; the middle lamp indicates that it is more than half full; when the upper lamp lights
up, the tank needs emptying as it can only take 2 - 3 further uses.
▲
The Waste Holding Tank Level Indicator will flash when the holding tank is not present. In
this case the toilet will not flush.