Bailey Caravan, Руководство пользователя

Страница: 32 / 127

3-5
Caravan Service Systems
3
3.1.6 Routine Maintenance
●
Ensure the hose adapter ‘O’ ring and the socket in the housing are kept free from dirt.
●
Use only silicone or water based lubricant to inlet nipple ‘O’ rings on socket for lubrication.
●
Drain system thoroughly during the winter months, (see separate winterisation instructions).
●
Service inlet socket annually, (use Whale’s AK8834 service kit containing all serviceable parts).
●
Change Aquasource Inline filter (on Pageant only) once per season positioned beneath kitchen
tap.
3.1.7 Cleaning Containers and the System
●
Cleaning instructions for both water containers and the water system are detailed in general
maintenance section of the handbook.
3.1.8 Pressure switch (Discovery & Ranger)
Operation
The pressure switch detects the opening or closing of any tap in the system and switches the pump on
or off accordingly.
At normal flow rate the pump should operate continuously - but at low flow rates the pressure switch will
cycle on and off to maintain back pressure in the pipework.
3.1.9 Adjusting Pressure Switch (Discovery & Ranger)
If the battery voltage is not constant, cycling may occur even at higher flow rates. This can be minimised
by adjusting the switch’s diaphragm sensitivity as follows:
●
With the system properly primed, close all taps and showers.
●
Leave the power supply turned on.
●
Tighten the adjusting screw (clockwise). The pump should now be running.
●
Partly open one cold tap to allow water to flow.
●
Now slowly loosen the adjusting screw until the switch starts to click. The switch will then be properly
adjusted.
3.1.10 Onboard water supply (Senator only)
This is located under the chest of drawers at the front of the caravan.
Firstly ensure that the drain tap, located on the front offside of the caravan, is shut.
To fill, place the carbon filter assembly hose inside a filled water container before inserting the plug in
the caravan wall socket.
The capacity of the inboard water tank is approximately 42 litres (9.2 gallons)
Water can now be obtained from the in-board tank by switching pump switch on the control panel and
opening the appropriate valves (as per fig. 3 on page 3-2).
An LED located on the main control panel will flash on and off when the onboard tank water level falls
to approximately 2 gallons.
Always ensure that the in board water tank is empty when towing.