Assembly:
The following minimum tools are required:
•
9/16” Wrench
Any of these additional tools will make assembly easier:
•
9/16” socket and drive ratchet
[Refer to Figure 2, opposite page]:
Place the Table Top and Apron Assembly upside down on a
smooth, clean surface. Place one Corner Leg in each corner
at the gap in the Apron, with the notch and starter hole facing
inside towards the Corner Brace. Attach each of the four (4)
Corner Legs using one (1) Lag Bolt, Lockwasher and
Flatwasher as shown in Figure 2. Tighten each Lag Bolt
gradually and in sequence between the four corners until the
Lockwasher flattens out and the Corner Leg is drawn
securely into the Apron gap.
Note: Tightening each corner fully before starting the next
one may result in a warped or distorted Table. If this occurs,
loosen all Lag Bolts until Table flattens out, and gradually
retighten Lag Bolts in sequence.
Turn Mat Table upright and place in location to be used. The
floor should be flat and level as possible.
Check all fasteners and components for proper tightness and
fit. Your Mat Table is now ready to use.
Safety:
Be safe! Never attempt to assemble or move a table yourself;
always seek assistance. Avoid placing the table against walls
or in contact with other equipment in order to eliminate pinch
points. Always observe Table Static Load Ratings as stated
on page 4.
Page 6
Model 9920 Basic Stationary Mat
BAILEY MANUFACTURING COMPANY
800-321-8372 • FAX: 800-224-5390
