Baileigh SS-2421-V2, Руководство оператора

Страница: 46 / 64

43
43
Pulley Alignment
Improper pulley alignment sharply reduces the effectiveness of power transmission and belt life
expectancy.
1. Disconnect and lockout power to the shaper!
2. Open the motor cover on the side of the shaper
cabinet.
3. Check the alignment with a straightedge. If the
pulleys are in alignment, the straightedge
should touch two sides of each pulley evenly.
4. If pulleys are parallel with each other, but not in
line, remove the belt from the spindle assembly
and slide the spindle cartridge assembly either
up or down.
Note: The side cover can be removed from the shaper to improve access to the
motor.
7. Inspect for tilt on the motor pulley. If the pulley is tilted, loosen the four bolts holding the
motor onto the motor plate. Wiggle the motor into position. (Do not loosen the bolts that hold
the motor onto the motor mount; this plate is preset with blocks that hold it in position and it
cannot be adjusted.)
8. Inspect your results. If they are satisfactory, tighten all fasteners. Remember to tighten the
bolt in the split housing that holds the spindle cartridge in position.
NOTICE: DO NOT over-tighten. Cast iron threads are more easily stripped than
steel.
9. You can also align the motor pulley by raising or lowering it along the motor shaft. Loosen
the two setscrews and tap into the desired position with a dead blow hammer.