Baileigh SS-2421-V2, Руководство оператора

Страница: 33 / 64

30
30
EDGE SHAPING: SHORT BOARDS
When edge shaping short boards, never attempt to hand
guide any stock less than 12 inches long, or narrower than
3 inches without the use of a special guide as shown in
Figure 14.
END SHAPING
When end shaping narrow stock, it is important
that at least one half of the workpiece end be in
contact with either the infeed or outfeed fence as
shown in Figure 15.
Use a guide similar to the one shown in Figure 15
which tightly clamps the scrap piece to the
workpiece and provides the necessary width.
SHAPING ALL SIDES
Because cross grain shaping is more likely to create
chipping out end splinters on some woods, it is good
practice to first shape the cross-grain sides. Any chipping
that does occur is taken care of by the with-grain cuts, as
shown in Figure 16.
WARNING:
End shaping a narrow workpiece without a special guide
could result in the workpiece rocking into the cutterhead causing minor, or major,
personal injury.