Baileigh SR-5016M, Руководство оператора

Страница: 14 / 24

12
12
OPERATION
Before using the Baileigh SR-5016M Slip Roll, check the mounting and adjustment of the
machine. Rotate the handle and check whether the two gears have good, firm contact with each
other. All three shafts should be clean and free of any metal debris.
DO NOT exceed the rated capacity on this slip roll. It has been tested at the factory to roll 16ga.
(1.51mm) x 50
” (1270mm) wide mild steel.
The SR-5016M slip roller has three 3
” (76.2mm) diameter rolls. The two front rolls, one placed
vertically above the other are clamping rolls. The top roll is fixed and the bottom roll is adjustable
with two knobs (A). The rear idler roll controls the diameter of the finished piece part and is
adjusted with two bolts (B). Always make sure the gap along the full length of the rolls is
consistent. If the rolls are not adjusted exactly parallel, the material will spiral during the rolling
process, Because material springback varies with the kind of material being formed, only by test
forming several pieces can the correct adjustments be made.
CAUTION:
Always wear proper eye protection with side shields, safety
footwear, and leather gloves to protect from burrs and sharp edges. When handling
large heavy sheets make sure they are properly supported.
figure 2
A
B
Bottom Front Roll
Rear Idler Roll
Top Front Roll
Shown with gear
Cover removed