Baileigh DP-1250VS, Руководство оператора

Страница: 33 / 56

30
30
Return Spring
The spindle return is preset by the manufacturer and should not
need adjustment.
If future attention is ever required, proceed as follows:
1. Do NOT remove spring cap.
2. Loosen screw (A) just enough to rotate spring cap (B) past pin
(Inside case. Not normally visible.) and engage pin into next
notch.
3. Rotate spring cap clockwise to decrease spring tension. Rotate
spring cap counterclockwise to increase spring tension.
4. Tighten both screws (A).
Replacing Gearbox Oil
•
1st Time: After initial operation of 30 hours.
•
2nd Time: After 1 month of operation
•
3rd Time: Every 12 months of operation
1. To change the oil you need to remove the cover
plate on the underside of the head.
2. Remove the oil drain plug (AI) visible through the
access hole. (Have a drain pan or container handy to collect
the used oil). Be sure the gearbox is completely empty before
putting the oil drain plug back in.
3. Remove the oil add cover plate (AJ) covering the oil fill tube
and fill the gearbox with fresh SAE 80W-90 gear oil until it
reaches the center of the oil sight window (T).
Oil Disposal
Used oil products must be disposed of in a proper manner following your local regulations.
T
AJ
AI
A
B