Baileigh CS-250EU, Руководство оператора

Страница: 27 / 60

24
24
OPERATION
Miter Angle
1. Push the miter lock lever (A) to the left to release
the disk head assembly.
2. Rotate the disk head assembly to the desired miter
angle.
3. Use the indicator scale (B) to set the desired cut
angle. (Fine tune the angle as needed to get the
exact angle.
4. Pull the miter lock lever (A) back to the right to lock
in the angle. ALWAYS LOCK THE LEVER
BEFORE CUTTING.
5. Adjust the vise clamping jaw (C) to allow for the
blade to clear the vise without contacting the jaw.
Important: Never allow the saw to cut
into the vise jaws.
6. Loosen the clamping bolt (D) and slide the jaw left
or right as needed to clear the saw blade. The jaw
should be between 0.25” and 0.5” (6 – 13mm) with
out contacting the saw blade.
7. Adjust the clamping support to the right side of the
blade by loosening and the mounting bolt and
sliding the support within the slots (E) or when
needed, changing the slots. If absolutely necessary, the clamping support may be removed.
CAUTION:
Always wear proper eye protection with side shields, safety
footwear, and leather gloves to protect from burrs and sharp edges.
When handling large heavy material make sure they are properly supported.
CAUTION:
Check that the cutting blade clears all parts of the vise
assembly before cutting. The blade can strike parts of the assembly (especially
during miter cuts) if not properly adjusted.
D
C
E
A
B