Baileigh BSV-24VS, Руководство оператора

Страница: 44 / 48

41
41
SYMPTOM POSSIBLE CAUSE (S) CORRECTIVE ACTION
Hard spots in or on material.
Blade installed backwards.
Insufficient blade tension.
Scale: Reduce speed, increase
feed pressure. Hard spots:
Increase feed pressure.
Remove blade twist inside out
and reinstall blade.
Increase tension to proper
setting.
Bad Cuts (Crooked)
Work not square.
Feed pressure too great.
Inadequate blade tension.
Blade guides spaced out too far.
Dull blade.
Speed incorrect.
Blade guide assembly loose.
Blade tracks too far away from
wheel flanges. Adjust table to be square with
blade.
Reduce pressure
Increase blade tension a little at a
time.
Move guide approx. .25” (6.3mm)
to piece part.
Replace blade.
Check manual for recommended
speeds.
Tighten.
Re-adjust tracking per
instructions in this manual.
Machine is Noisy or
Has Excessive
Vibration
V-belt(s) loose or worn.
Loose pulley.
Motor mount loose or broken.
Noisy motor bearings.
Excessive blade noise.
Replace belt(s). Matched set as
required.
Tighten bolt, nut, or shaft key.
Tighten or replace if broken.
Replace bearings.
Re-tension or replace blade. Poor
Blade weld
Machine Slows Down
While Operating Feeding piece part too quickly.
Reduce feed pressure / increase
blade speed.