Baileigh BS-916M, Руководство оператора

Страница: 31 / 52

28
28
Automatic Shut-Off Adjustment
The motor shall shut off immediately after the blade
has cut through the material and just before the head
comes to rest on the horizontal stop bolt.
1. If the machine continues to run after the workpiece
has been fully cut, locate and adjust the micro
switch stop bolt (A) by moving the stop bolt up.
2. If the machine shuts off before the workpiece has
been completely cut, move the micro switch stop
bolt (A) down.
3. Tighten the jam nut when the adjustment is
complete.
Thrust Roller Adjustment
1. Disconnect machine from the power source.
2. Loosen two hex socket cap screws (A).
3. Move guide seat (B) up or down until a
clearance of 0.003” to 0.005” between back
of blade and thrust roller is obtained.
4. Tighten two hex socket cap screws (A).
5. Repeat for other blade guide assembly.
6. Connect machine to power source.
A
B
A