Baileigh BS-300M, Руководство оператора

Страница: 20 / 56

17
17
4. Route the belt guard behind the pullies and around
the motor and gearbox shafts.
5. Mount and secured the guard assembly to the
bow.
6. Install the belt onto the pullies making sure that the
belt is on the same pulley groove for both pullies.
Your machine is provided with four speeds.
1. Install the belt onto the desired grooves on the
pulleys and adjust belt tension by lifting/pulling the
motor plate back and up until the belt is tight.
Tighten the tension lock bolt.
2. Close belt and pulley guard cover and secure in
place with the thumb screw.
3. Route the motor wire harness up to the junction
box on the motor.
4. Remove the junction box cover.
5. Route the wires into the junction bow using the
strain relief to hold the harness into the box.
6. Connect the green wire with the ring terminal to the
ground screw on the base of the junction box.
7. Using the wire nut, connect the V1 wire to one of
the black wires from the motor by twisting the wire
strands together and then securing the connection
with the wire nut.
8. Connect the other wire from the harness to the remaining motor wire and secure the wire
nut.
9. Carefully tuck the wires inside the junction box and install the cover being careful not to
pinch the wires.