Baileigh B-CART-W, Сборка и каталог запасных частей

Страница: 6 / 16

6
Figure 4-5
6. Turn the cart assembly upside down.
CAUTION: Cart is heavy. To avoid injury,
use two or more people to turn cart to upside
down.
Turn the Base (item #1) upside down and place on
the cart assembly as shown in Figure 4-6. Make
sure the Axle-end of the base is located on the
Tank-Support-side of the cart assembly.
Figure 4-6
7. Align the mounting holes on each Side Panel
flange with the mounting holes on each side of the
Base. Place the Casters (item #3) in the corners
of the Base as shown in Figure 4-6. Align the
Caster mounting holes with the mounting holes in
the Side Panel flange and Base. Attach Casters,
Base, and Side Panel using eight M8 x 20 Round-
Head Square-Neck Carriage Bolts (item #2) with
M8 Flanged Nylock Hex Nuts (item #4), as shown
in Figure 4-6. Finish attaching Side Panels to Base
using seven M8 x 20 Round-Head Square-Neck
Carriage Bolts (item #2) with M8 Flanged Nylock
Hex Nuts (item #4), as shown in Figure 4-7.
Fully-
tighten all nuts from steps 2 and 3, then fully-
tighten all nuts from step 7.
Figure 4-7
8. Loosen the set screw (item #8) in the four Limit
Rings (item #7) (see Figure 4-8). Slide a Limit Ring
over each end of the Axle (item #5), followed by a
Wheel (item #6) and the remaining Limit Ring.
Snug the Limit Rings and Wheels to the Base.
Fully-tighten the Limit Ring set screws to the
Axle.
Figure 4-8
9. Turn the cart assembly over to the upright position.
CAUTION: Cart is heavy. To avoid injury,
use two or more people to return cart to
upright position.
10. Using two M8 x 20 Round-Head Square-Neck
Carriage Bolts (item #2) with M8 Flanged Nylock
Hex Nuts (item #4), attach top Tig Filler Rack (item
#11) to cart assembly Side Panel as shown in
Figure 4-9.
Fully-tighten these nuts.