Baileigh Industrial WL-1218VS, Руководство оператора

Страница: 48 / 52

45
45
Vibration noise while
machine is running; noise
remains constant when
speed is changed.
1. Dented fan cover on motor.
1. Replace or adjust fan cover.
Inspect motor fan and replace if
damaged.
Chisels grab or dig into
workpiece.
1. Tool rest set too low.
2. Tool rest set too far from
workpiece.
3. Wrong chisel/tool being used.
4. Chisel/tool dull.
1. Set tool rest higher.
2. Move the tool rest closer to
the workpiece.
3. Use the correct chisel/tool;
educate yourself by reading
books, trade magazines, or
seeking help from an
experienced lathe operator.
4. Sharpen or replace the
chisel/tool you are using.
Bad surface finish.
1. Wrong spindle speed.
2. Dull chisel or wrong chisel
being used for the operation.
1. Use trial-and-error to find a
better spindle speed.
2. Sharpen chisel or try a
different chisel.
Tailstock moves.
1. Tailstock mounting bolt loose.
2. Too much clamping pressure
applied by tailstock.
3. Bed surface is oily or greasy.
1. Tighten.
2. Apply less clamping pressure
with tailstock.
3. Clean bed surface to remove
oil/grease.
Cannot remove tapered
tool from tailstock barrel.
1. Tailstock barrel had not
retracted all the way back into
the tailstock.
2. Debris was not removed from
taper before inserting into
barrel.
1. Turn the barrel handwheel
until it forces taper out of barrel.
2. Always make sure that taper
surfaces are clean.