9
9
23. Know the location of the
ON - OFF
switch and the
“E”- STOP
button.
24.
Removing Piece Parts.
Before removing cut-offs, always turn the saw
OFF
, and wait for the
blade to stop moving.
25.
Blade Guide Positioning.
Adjust and position the upper and lower blade guides before
starting the cut. The upper blade guide should be positioned approximately 1/8” (3mm)
above the material.
26.
Blade Adjustment.
Adjust the blade tension and tracking before starting the cut.
27.
Supporting Piece Part.
Provide adequate support to the sides and front of the band saw for
material that is extra wide and long.
28. Keep visitors a safe distance from the work area.
29.
Keep children away
. Children must never be allowed in the work area.
DO NOT
let them
handle machines, tools, or extension cords.
30.
DO NOT operate machine if under the influence of alcohol or drugs
. Read warning
labels on prescriptions. If there is any doubt,
DO NOT
operate the machine.
31.
DO NOT
touch live electrical components or parts.
32.
Be Sure
all equipment is properly installed and grounded according to national, state, and
local codes. If machine is equipped with a three-prong plug, it should be plugged into a
three-hole electrical receptacle. If an adapter is used to accommodate a two-prong
receptacle, the adapter plug must be attached to a known ground. Never remove the third
prong.
33. Inspect power and control cables periodically. Replace if damaged or bare wires are
exposed.
Bare wiring can kill!
34.
Maintain machine in top condition
. Keep clean for best and safest performance. Follow
instructions for lubricating and changing accessories.
35.
Reduce the risk of unintentional starting
. Make sure switch is in
“OFF”
position before
plugging in power cord.
36.
Never leave machine running unattended. TURN POWER OFF
. Don’t leave machine until
it comes to a complete stop.
37.
Make sure machine is disconnected from power supply
while motor is being mounted,
connected or reconnected.
38.
Saw Appropriate Material.
Only use this saw for natural wood stock and wood stock
products such as particle board, plastics, laminates, and medium-density fibre board (MDF).
DO NOT try and cut metal, glass, ceramics, or products containing asbestos or lead paint.
Some of these materials contain hazardous dust and can cause severe respiratory
problems.
Содержание WBS-12
Страница 28: ...26 26 PARTS DIAGRAM...
Страница 33: ...31 31 NOTES...
Страница 34: ...32 32 NOTES...
Страница 35: ...33 33 NOTES...
