Baileigh Industrial PH-28HD-VS, Руководство оператора

Страница: 16 / 39

14
14
9. Next, adjust the stroke as needed to provide the amount of force desired to produce the
results desired. The longer the stroke, the greater the force generated. When starting for the
first time, use the factory setting (typically the mid-point) until some practice has occurred to
become familiar with the machines operation.
Operation
1. Set the control switch to the “ON Foot Control”
position.
2. Set the limiting potentiometer to 100%, about 1000
BPM (Beats Per Minute), slowly press the foot
control, the machine should begin to “hammer”,
hitting harder the faster you go.
3. Turn the main disconnect to ON.
4. Shrinking as well as most of the shaping functions
will take time to learn and control. To practice
shrinking, use 3003-H14 .059 wall aluminum. This
is a good material to learn on because it shapes
easily and is more forgiving. To shrink start feeding
the metal in slowly controlling the shrink by your
foot control; slowing as you pull out not to flatten
the edge too much.
5. The hammer mode is also used for planishing.
Install the flat top die and the 6000R x 1000F lower
hammer die. This die has a contact patch of 1”
diameter. Install the tools following the same steps as before. Adjusting the stroke will give
different results. Shortening the stroke will allow different speed settings, faster speeds can
be achieved by finding the “sweet spot”, just before the spring begins to float. The
combinations of stroke / speed / down feed are almost endless.
6. These dies can be used for planishing as well as stretching. The flat top die is used for most
of the stretching applications except for aggressive doming. The rubber die can be installed
on either the top or bottom depending on your application.
WARNING:
The tools on this machine should never come in contact with
each other, if they do, machine damage will occur.