Baileigh Industrial IDX-10, Руководство оператора

Страница: 26 / 40

24
24
9. Next, starting at the rear of the table, peel back the covering of the
magnetic strip (thick dark colored strip) and carefully begin to stick
to the side of the table. Stay flush to the bottom of the table as seen
in Fig. 7. Another person may be necessary to help hold the end of
the magnetic strip.
10. With the magnetic strip securely stuck to the
side of the table, it is time to stick the
protective cover strip on the top of the
magnetic strip. Again, starting at the rear of
the table, stick the cover strip directly on top of
the magnetic strip. (Fig. 8) Trim off the extra
material after the magnetic strip has been
covered. CAUTION: The cover strip is very
fragile and will bend very easily. Use extra
caution during application.
11. Reattach the table back to the bender and the
adjustment leg.
12. Put the roller base back onto the table, make
sure that the eccentric V-rollers are still loose and that the V-rollers attach to the track on the
table properly.
13. Adjust the eccentric V-rollers so they become tight on the track. Hold the eccentric in place
and tighten the HHCS. There should be no wiggle between the V-rollers and the track on the
table.
14. Notice the sensor should be in the middle of the magnetic strip.
(Fig. 7)
Magnetic Strip
Cover Strip
(Fig. 8)