Baileigh Industrial DP-1850G, Руководство оператора

Страница: 18 / 52

15
15
4. Install the motor into the drill head. Align the motor
with the flat of the mounting plate toward the front
of the drill head and the motor conduit box toward
the left side of the drill head.
5. Install the four cap screws and lock washers and
tighten the motor into the drill head.
6. Remove the conduit box cover and route the
electrical harness from the top of the electrical
cabinet into the motor conduit box.
7. Thread the strain relief into the conduit box.
8. Connect the ground wire (PE) to the ground
terminal at the bottom of the box.
9. Make the wire connections as follows;
a. U3 to V2,
b. V3 to U2, and
c. W3 to W2.
10. Install the conduit box cover.
Coolant
Fill the coolant water reservoir located in the base of
the machine to 80% capacity. The sight glass window
(A), at the side of the base, indicates the level.
Filling or adding coolant may be done by removing the
return cover on the side of the base, or by slowly
pouring the coolant into the base table and allowing it
to drain into the reservoir.
U3
V3
W3
PE
A