Baileigh Industrial CS-315EU, Руководство оператора

Страница: 39 / 56

36
36
Yearly Maintenance
Change the oil in the gear case as follows:
1. Lower the saw head to the horizontal (down)
position.
2. Disconnect the trigger cord from the electrical box
and unscrew the feed handle (A) from the gear
case.
3. Place a container under the drain hole (B) and
remove the drain plug allowing the oil to drain.
4. Install the drain plug.
5. Raise the head to the up position.
6. Fill the gear case with oil through the feed handle
mounting hole (C) to the top of the sight gauge
(D).
7. Install the feed handle and connect the trigger
cord to the electrical box connector.
Oil Disposal
•
Used oil products must be disposed of in a proper manner following local regulations.
Accessing and Cleaning the Coolant System
1. Remove the drain hose from the return screen.
2. Lift the tank and pump assembly off of the
retaining tray and slide the assembly out of the
stand.
3. Remove and clean the filter (A). Replace if
needed.
4. Pour out the coolant from the tray.
5. Wash out the dirt and debris.
6. Replace the filter and install the pump and tank
assembly so that the V-notch is over the retaining
flange.
7. Fill the tank with coolant solution by pouring coolant through the chip strainer (A).
D
C
A
B
A