Baileigh Industrial BB-12010H, Руководство оператора, Страница: 32 / 52

29
29
FACTORY SETTINGS for CLAMPING BEAM
The factory settings for 10 ga. (.1345”) mild steel. To return your machine to these settings, the
arrow for the material thickness gauge needs to be set at slightly more than the 1/8” increment
as shown in the figure 23. The right side of the gauge is divided into 1/32”s of an inch. To
decrease the reading on the gauge:
1. Back off locknuts “
B ” and “ D ”.
2. Turn Adjusting bolt “ A ” ccw ( counterclockwise )
to back off about 1/16” from the square slider
shaft.
3. Turn bolt “ C ” ccw ( counterclockwise ) until the
square slider shaft pushes against the bottom of
bolt “
A ”.
4. Check the reading on the gauge. It should be
less than it was. Repeat steps 2 and 3 if
necessary to bring you down to .1345”.
5. If bending 16 ga. (.0598”) line up the arrow to
read slightly less than 1/16” on the gauge.
6. When bolts “ A ” and “ C ” are tight against the
square slider and you have the gauge set
properly, tighten locknuts “
B ” and “ D ”.
7. To increase the dimension on the gauge,
reverse the above adjusting bolt procedure.
figure 23
A
B
C
D
0
1
10 ga.
(.1345)