Nova846 Outdoor 8x5W Two-Carrier TDD eNodeB Installation Guide
18
3.
Hang the eNB (with bracket) onto the pole bracket. Ensure the screw on the bottom of the
bracket clips into the groove on the pole bracket, and then fasten the screw with a Phillips-
head screwdriver to complete the installation (Figure 3-6).
Figure 3-6: Attach eNB to Bracket
4.
After installation is complete, adjust the eNB to a proper angle by tilting.
3.3.2 Install on Wall
Ensure that the wall can bear at least four times the weight of the eNB. Follow the steps below to
install the Nova846 eNB on a wall.
1.
Take apart the assembled installation bracket.
2.
Place the installation bracket on the wall, ensuring the groove is located on the bottom of
the bracket, as shown in Figure 3-7. Mark the two drilling locations using a pencil or marker.
3.
Drill two holes in the wall to match the size of the wall bracket holes (Figure 3-7).
Figure 3-7: Mark and Drill Holes