Nova-436 Outdoor LTE TDD Base Station Installation Guide
13
devices. Avoid interference from other transmitting antennas to the GPS antennas.
Should be installed within 45 degrees to the lightning rod.
The GPS has been assembled before packing, the only installation step is to fix the GPS
mounting bracket on the base station with the M4*14 screws, as shown in Figure 3-2.
Figure 3-2 Install GPS Antenna
Install on Pole
3.4
Required diameter of the pole: 40mm ~ 100mm. Suggest the installation height higher
than 120cm.
The base station bracket has been assembled before packing. In the installation site, the
installation persons only need to fix the assembled base station on pole.
1. Take down the two outer omegas.
2. Make sure installation height of the base station, fit the thread rod of the assembled
bracket to the pole, and then pass the two omegas through the threaded rods, and
fasten with four flat gaskets, four spring gaskets, and four nuts.
