Page 6
For technical questions, please call 1-888-866-5797.
Item 58395 58448
Record Product’s Serial Number Here:
Note:
If product has no serial number, record month and year of purchase instead.
Note:
Some parts are listed and shown for illustration purposes only, and are not available individually
as replacement parts. Parts may not be interchangeable. Specify item number when ordering:
48″ Trail Jack (58395): 193175438621
60″ Trail Jack (58448): 193175439239
User-Maintenance Instructions
Procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise occurs, have the problem corrected before further use.
TO PREVENT SERIOUS INJURY:
Remove load from the jack before any procedure on this page.
1.
BEFORE EACH USE,
inspect the general
condition of the equipment. Check for:
• loose hardware
• misalignment or binding of moving parts
• cracked or broken parts
• any other condition that may
affect its safe operation.
• lubricate moving parts of the
Jack with lubricating oil.
Note:
Using Jack without proper lubrication can result
in poor performance and damage to Jack. The front
and back of the Steel Rail must be kept rust free.
Note:
Do not use motor oil or grease to lubricate Jack.
2. Before each use and after the inspection,
thoroughly test the Jack for proper
operation prior to its actual use.
3.
AFTER USE,
clean the tool with clean cloth.
4. Store the Jack in a safe, dry location out of reach
of children and other non-authorized people.
a. Place Handle in upright clipped position
against Steel Standard Bar.
b. Raise the Reversing Latch until
it locks in the up position.
c. Store in the upright clipped
position in a dry location.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM
IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR
MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS
QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO REPLACE
ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY
STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND
LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY
ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS
THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
