Page 13
For technical questions, please call 1-888-866-5797.
Item 63476
S
AFET
y
O
PERA
TION
M
AINTENANCE
S
ETUP
Maintenance and Servicing
Procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO PREVENT SERIOUS INJURy FROM ACCIDENTAL OPERATION:
Disconnect the Battery Cables before performing any
inspection, maintenance, or cleaning procedures.
TO PREVENT SERIOUS INJURy FROM WINCH FAILURE:
Do not use damaged equipment. If abnormal noise or vibration
occurs, have the problem corrected before further use.
Cleaning, Maintenance, and Lubrication
1.
BEFORE EACH USE,
inspect the general
condition of the winch. Check for loose hardware,
misalignment or binding of moving parts, cracked
or broken parts, damaged electrical wiring,
corroded or loose terminals, and any other
condition that may affect its safe operation.
Examine the wire rope. Do not use the winch if
the wire rope is frayed, kinked or damaged.
2.
AFTER USE,
wipe external surfaces
of the winch with clean cloth.
3. Lubricate the wire rope occasionally with a light oil.
4. The winch’s internal mechanism is
permanently lubricated. Do not open the housing.
However, if the winch is submerged, it should be
opened, dried, and re-lubricated by a qualified
technician as soon as possible to prevent corrosion.
Wire Rope Replacement
1. Move Clutch Handle to the Released position.
2.
Extend the Wire Rope to its full length,
noting how the existing Wire Rope is
connected to the inside of the drum.
3. Remove old Wire Rope and attach new assembly.
WARNING!
Do not replace with inferior Wire Rope.
Only use a wire rope rated to the same rating
cited on the specification chart or better.
4. Retract Wire Rope onto Wire Rope
drum being careful not to allow kinking.
Refer to instructions for tensioning the wire rope
under Preparing the Wire Rope on page .
5.
Test Electric Winch for proper operation.
Programming the Remote
Receiver
Transmitter
Figure K
1. If either the Receiver or Remote is replaced,
the Remote needs to be programmed.
2. To clear the previous program, press and hold both
EXTEND & RETRACT buttons simultaneously for
20 seconds until the LED flashing turns solid.
3.
Press and hold both EXTEND & RETRACT
buttons again for 3 seconds until LED
turns off and then lights up.
