Disclaimer
May 2019
LM_OG-AM_BA_02_1163
Page 1
1.
DISCLAIMER
The user/purchaser is expected to read and understand the information provided in this manual, follow any listed safety
precautions and instructions and keep this manual with the equipment for future reference. The information in this manual
has been carefully checked and is believed to be entirely reliable and consistent with the product described. However, no
responsibility is assumed for inaccuracies, nor does Badger Meter assume any liability arising out of the application and use of
the equipment described. Should the equipment be used in a manner not specified by Badger Meter, the protection provided
by the equipment may be impaired and the warranty voided. The meter is conform to the MID regulations for liquids other
than water.
2.
BASIC SAFETY RECOMMENDATIONS
Before installing or using this product, please read this instruction manual thoroughly. Only qualified personnel should install
and/or repair this product. If a fault appears, contact your distributor.
Installation
Do not place any unit on an unstable surface that may allow it to fall.
Never place the units above a radiator or heating unit.
Route all cabling away from potential hazards.
Isolate from the mains before removing any covers.
Power connection
Use only the type of power source suitable for electronic equipment. If in doubt, contact your distributor. Ensure that any
power cables are of a sufficiently high current rating. All units must be earthed to eliminate risk of electric shock. Failure to
properly earth a unit may cause damage to that unit or data stored within it.
Protection class
Following devices have protection class IP65:
LM OG-AM
Standard inline meter
LM OG-KAM
Coated standard inline meter
LM OG-CDAM
Pistol meter with handle, sightglas and swivel
LM OG-CNDAM
Pistol meter with handle, sightglas, swivel and outlet
LM OG-TAERM
Inline meter with pulse output
LM OG-TAERKM
Coated inline meter with pulse output
All devices have to be protected against dripping water, water, oils, etc.
Setup & operation
Adjust only those controls that are covered by the operating instructions. Improper adjustment of other controls may result
in damage, incorrect operation or loss of data.
Cleaning
Switch off all units and isolate from mains before cleaning.
Clean using a damp cloth. Do not use liquid or aerosol cleaners.
