Badger Meter LM OG Series, Инструкция по эксплуатации и техническому обслуживанию, Страница: 12 / 32

Disclaimer / Basic safety recommendations Page 10/28
LM_OG_BA_98_1105
1. Disclaimer
The user/purchaser is expected to read and understand the information provided in this
manual, follow any listed safety precautions and instructions and keep this manual with
the equipment for future reference. The information in this manual has been carefully
checked and is believed to be entirely reliable and consistent with the product described.
However, no responsibility is assumed for inaccuracies, nor does Badger Meter, Inc.
assume any liability arising out of the application and use of the equipment described.
Should the equipment be used in a manner not specified by Badger Meter, Inc., the
protection provided by the equipment may be impaired and the warranty voided.
2. Basic safety recommendations
Before installing or using this product, please read this instruction manual thoroughly.
Only qualified personnel should install and/or repair this product. If a fault appears,
contact your distributor.
Installation
Do not place any unit on an unstable surface that may allow it to fall.
Never place the units above a radiator or heating unit.
Route all cabling away from potential hazards.
Isolate from the mains before removing any covers.
Power connection
Use only the type of power source suitable for electronic equipment. If in doubt, contact
your distributor. Ensure that any power cables are of a sufficiently high current rating.
All units must be earthed to eliminate risk of electric shock.
Failure to properly earth a unit may cause damage to that unit or data stored within it.
Protection class
Following devices have protection class IP 42:
•
LM OG-A
•
LM OG-RFK
•
LM OG-CDA
•
LM OG-T100
•
LM OG-CNDA
•
LM OG-T200
•
LM OG-HFT
•
LM OG-TAEK(A)
•
LM OG-P2 Advanced
•
LM OG-TAE(R) 200
•
LM OG-PA
•
LM OG-TK 100
•
LM OG-PK
Following devices have protection class IP 67:
•
LM OG
•
LM OG-CND
•
LM OG-K
•
LM OG-CNDK
•
LM OG-HF
•
LM OG-HF-CND
All devices have to be protected against dripping water, water, oils, etc.
Setup & operation
Adjust only those controls that are covered by the operating instructions. Improper
adjustment of other controls may result in damage, incorrect operation or loss of data.