Badger Meter F001, Руководство по установке

Страница: 8 / 28

General description
Seite 4 December 2019 AC_F001_IA_02_2243
4. A-OUT
4.1 mode Output disable - enable
4.2 r.min Rate min 0.000 - 9999999
4.3 r.max Rate max 0.000 - 9999999
4.4 t.min Tune min 0 - 9999
4.5 t.max Tune max 0 - 9999
5. D-OUT
5.1 mode Output mode Off; Short; Long
5.2 decs Decimals 0; 0.1; 0.02; 0.003
5.3 amnt Amount 0.001 - 9999999
6. OTHERS
6.1 modl Model BASIC71
6.2 v-no Software version nn.nn.nn
6.3 s-no Serial number nnnnnnn
6.4 pin Pin code nnnn
6.5 bl Backlight on; off
3.4. Setup menu - Explanation
The settings for the (accumulated) total and flow rate are independent from each other. For this reason it is possible to have
for (accumulated) total and for the flow rate different engineering units, e.g. the (accumulated) total is set to m³ where the
flow rate is set to liters per time unit. For this reason you need to calculate and set the K-Factor for the (accumulated) total as
well as for the flow rate.
1. Total
1.1 unit This submenu is used to select the engineering unit for the indication of the total and the
accumulated total.
When you change the engineering unit for total, you must recalculate and enter the K-Factor for
the (accumulated) total. When you recalculate and enter the new K-Factor, the history for
(accumulated) total is not correct anymore, because the (accumulated) total is not recalculated.
For future reference, best practice is to make a note of the (accumulated) total before you enter
the recalculated K-Factor.
1.2 decs This submenu is used to set the amount of digits behind the decimal pointer for the (accumula-
ted) total indication.
1.3 k-f This submenu is used to set the K-Factor for the total. With the K-Factor, the flow meter pulse
signals are converted to a quantity. The K-Factor is based on the number of pulses generated by
the flow meter per selected engineering unit, for example per m³. A more accurate K-Factor (more
decimals, as set in kf-d) allows for a more accurate operation of the system.
1.4 kf-d This submenu is used to set the amount of digits behind the decimal pointer for the K-Factor.
The setting for the K-Factor decimals has an indirect effect on the accuracy of the K-Factor because
more decimals give a higher accuracy.