2.0/1008/TG
N
O
P
R
PICTURE 9
PICTURE 10
S
STEP 12 -
PICTURE 12
: Insert the drawer into the changing table. Angle the drawer so that you can slide the wheels
on the inside tracks (T) over and behind the wheels on the outside tracks (A); then holding the drawer level push it all
the way into the table. When properly installed the drawer will glide in and out smoothly and the wheels act as a stopper
to keep the drawer from falling out when fully opened.
Place the MATTRESS PAD (L) onto the TOP SHELF (H1)
underneath the SAFETY BELT (I).
PICTURE 11
T2
PICTURE 12
L
YOUR CHANGING TABLE IS ASSEMBLED!
DO NOT USE THIS PRODUCT UNTIL YOU HAVE
REVIEWED THE SAFETY INSTRUCTIONS ON PAGE 2!
Remember that you can accessorize this table with up to
four Badger Nursery Baskets (sold separately)!
Browse our selection at www.badgerbasket.com!
B2
B1
Page 6 of 6
STEP 9
-
PICTURE 9
: Insert the METAL PINS (M), and the wooden pegs, on the LEFT (N) and RIGHT SIDE
PANELS (O) into the holes on the side edges of the BACK PANEL (P). Be sure all of the shelf grooves are lined up.
Insert TWO ROUND METAL CAMS (Q) into the holes on the BACK PANEL (P) with the arrows on the cams
pointing towards the heads of the metal pins. Turn the cams clockwise using a standard screwdriver until they lock over
the heads of the pins. Insert the BOTTOM PANEL (R) into the grooves and be sure it’s seated on all three sides.
STEP 10 - PICTURE 10
: Repeat the pin and cam procedure from Step 9 to attach the FRONT PANEL (S) to the
LEFT (N) and RIGHT SIDE PANELS (O). Be sure the BOTTOM PANEL (R) is properly seated in the grooves on all
four sides.
STEP 11 - PICTURE 11
: With the drawer upside down, attach the TWO INSIDE DRAWER TRACKS (T1 and T2) to
the SIDE PANELS (N, O) using the pre-drilled holes and THREE ½” SCREWS (C) for each track. The wheels on the
tracks line up with the back edge of the drawer.