2.0/1008/TG
Page 4 of 6
STEP 1
- PICTURE 1
: Attach the TWO OUTSIDE DRAWER TRACKS (A1 and A2) to the TWO END PANELS (B1, B2)
using SIX ½” SCREWS (C) (three screws for each track). Line up the first hole behind the track wheel so that all three screw
holes on (B) match up to holes on (A), and the narrower end of (A) lines up with the end of the track board.
STEP 2
- PICTURE 2
: Insert the SIXTEEN BLACK PEGS (D) into the peg holes on the ends of the TWO TOP
RAILS (E) and the SIX SHELF RAILS (F1, F2). Push the thinner end of the peg into the hole until the wider end is
flush with the wood.
STEP 3 - PICTURE 3
: Attach ONE TOP RAIL (E), ONE TOP SHELF RAIL (F1), and TWO MIDDLE/LOWER
SHELF RAILS (F2) to ONE END PANEL (B2 is shown, but you can begin with B1 if desired) using FOUR
1¾”
BOLTS (G). The grooves on the SHELF RAILS (F1, F2) face in and line up with the shelf grooves on the END PANEL
(B2).
STEP 4:
See PICTURE 4. Repeat Step 3 to attach the remaining TOP RAIL (E), TOP SHELF RAIL (F1), and TWO
MIDDLE/LOWER SHELF RAILS (F2) to the END PANEL (B2).
PICTURE 1
Track Board
B1
A1
Narrow End
E
F1,
F2
D
D
PICTURE 2
E
B2
F1
F2
F2
PICTURE 3
PICTURE 4
E
STEP 5 - PICTURE 5
: Rest the table on the END PANEL (B2). Insert the TOP SHELF PANEL (H1) and MIDDLE/
LOWER SHELF PANELS (H2) into the grooves on the SIX SHELF RAILS (F1, F2) with the white or colored sides
(depending on your model) of the shelves facing up. Be sure the shelves are seated into the grooves on all three sides.
B2
F1
F2
F2
*You must be sure to
use the F1 rails with
the thicker grooves
in the top positions.