Bitstorm Inc.
Bad Boy Xtreme N & MJ
www.bitstorm.com
7
Route the remaining cable to the location where the Power Adapter will be.
To prevent connector contact corrosion, apply corrosion inhibitor (included
under end cover) sparingly to the contacts of the device cable end connect-
or.
Note: A thin coating of corrosion inhibitor is all that is needed. Too thick
may result in floating connector pins and poor connections.
Xtreme N
: Put the cable end through bot-
tom cover and plug into Xtreme N. If conven-
ient, verify that Power LED lights. Investigate
if it does not.
Xtreme MJ
: Separate gland parts. Fit cable
through compression nut, find seal slip and
add around cable, and then fit through gland
body and plug into bottom of Xtreme MJ.
Xtreme N
: Screw the bottom cover on just snug.
Note: Do not over
tighten
. Seal the cable opening in the bottom cover using the white
grommet (included) which is split to allow it to be added onto the cable.
Check that the grommet is seated fully to ensure a weather tight seal.
Xtreme MJ
: Screw gland body onto Xtreme MJ. Then tighten compres-
sion nut until gland is tightly sealed around cable for water tight seal.
If cable was cut, locate the included Junction
Box kit. Using the included tool, strip back about
1 inch (2.5cm) of the outer jacket from both ca-
ble ends. Rotate the tool around the cable to
make a clean cut. Leave shield exposed. There
is no need to strip the insulation from the individ-
ual wires. Refer to photo.
Connect the wires to the spade terminals using
the tool’s metal tip. Lay the wire onto the spade
and push down with the tool. The spade will
pierce the insulation thus making electrical con-
tact. Ensure that both cables have the same
colour wire connected to the same pin number
on both left and right sides. Pin numbers may be
found on the actual block or on the cover. If the
Junction Box has wire colours shown next to the
spades, these can be used as a guide as well.
Refer to photo.
Note:
Junction Box may not be
exactly as shown. A suggested wiring order is:
1 Orange / White
5 Blue / White
2 Orange
6 Green
3 Green / White
7 Brown / White
4 Blue
8 Brown
Connect the shields of the cable on each side
together and secure the cable to the Junction Box by tie wraps or by crimp-
ing the retaining clasps to prevent stress. With shielded cable, strip back the
outer jacket and ensure that the retaining clasps or tie wraps are securely
contacting the foil shielding of the cable. Finish by snapping or screwing the
cover in place.
