Bitstorm Inc.
Bad Boy Xtreme N & MJ
2
www.bitstorm.com
IMPORTANT
Before You Install Your System
Your BAD BOY Wi-Fi system has been completely tested prior to shipment
going through multiple individual and system verifications including Wi-Fi
connectivity. Before cutting your cable or installing your system, take a few
minutes to bench assemble your BAD BOY components. Use your computer to:
1. verify system operation,
2. familiarize yourself with its behavior when operating, and
3. learn what to expect after installation.
Because a BAD BOY system can be installed in locations not easily accessible,
do not proceed with installation until you have verified that your system is
operating correctly. Contact us for assistance.
System failures after installation are usually caused by applying too much
corrosion inhibitor to the cable’s connector and incorrect wiring of the Junction
Box. Check that the cable’s colour coded wires match up correctly in your
Junction Box and that each wire is fully punched down. Your warranty may be
affected.
Declaration of Conformity
Bitstorm declares that this Bitstorm BAD BOY device is in compliance with the essential require-
ments and other relevant provisions of Directive 1999/5/EC.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two con-
ditions:
1.
This device may not cause harmful interference
2.
This device must accept any interference received, including interference that
may cause undesirable operation.
Your serial number will be found under the end cap of your Xtreme and is located under the bar
code. You can also find it on the Status tab in Xtreme’s management application. You may be
asked to provide your serial number when requesting support assistance.
________________________________________
Install Date:
Serial Number:
________________________________________
Record your management tool login credentials:
Username:
___________________________________
___________________________________
Password:
