Bad Boy GroundHog MAX, Руководство пользователя

Страница: 12 / 23

Compatibility Assembly(cont.)
Polaris 2006 and Newer and Similar
GroundHog MAX Receiver System
Installation Instructions
These instructions will work for most 2006 and
newer Polaris and other similar ATV’s. All nec-
essary hardware is provided.
1. Place 5/8-bolt (part 28-medium length or
part 8 short length depending upon space)
through the 9-inch extension tube (part 25A).
Utilize an existing hole in the frame of your
ATV. Install the bolt going upwards through
the frame and add a washer on top of the
frame for strength if possible. Fill any voids
with a washer between extensions tube and
the frame. Now put the nut on loosely at this
point.
2. Slide 21-inch receiver tube (part 25) into
9-inch extension tube (part 25A). Hold the
assembled tube up to the bottom of the ATV.
3. Place 1 tongue strap (part 16) under the
21-inch tube (part 25) and place another
tongue strap (part 16) on top of the existing 1
¼ -inch Polaris receiver hitch.
4. Install (2) long 5/8 inch bolts (part 16) up
through the bottom tongue strap (part 18) and
the existing triangular holes on the ATV and
the top tongue strap (part 18). Install lock
washers (part 23) and nuts (part 24). SEE
PICTURE TO THE RIGHT.
5. Gradually tighten all nuts securely on both
21-inch receiver tube (part 25) into 9-inch
extension tube (part 25A) tube assembly.
6. Place GroundHog MAX plow head (part
12) into the 21-inch receiver tube (part 25)
and secure with provided tractor pin (part 13)
and cotter (part 14).
NOTE: Polaris 550 and 850 Razor’s and
some others will need an aftermarket receiver
kit. View them at www.atvplowsplus.com
9 Compatibility Assemblies