Bad Boy CZT 6000 Elite Series, Руководство владельца, обслуживания и запасных частей

Страница: 23 / 52

The pump belt tensioner is located under the engine and has
a grease fitting at its pivot point. Grease at every engine oil
change.
The deck belt tensioner is located at the rear of the deck and
has a grease fitting on its pivot point. Grease at every engine
oil change.
The control arm blocks have grease fittings located on the
top of each block. Grease one time a year.
SECTION 6: CUTTING DECK
Deck belt removal: (1) Remove ignition key. (2) Slide the
tension adjustment bolt to its most rearward position in
order to provide the lowest belt tension possible. (3) Raise
the deck to its highest position. (4) Remove either the right
or left blade pulley cover. (5) While lifting up on the belt (as
shown in the photograph), rotate the pulley until the belt is
free of the pulley. Exercise caution while performing this step as fingers can easily become caught between the belt
and pulley.
For optimal cutting performance, the blade enclosure
should be level from right to left and have a slight forward
tilt downward. To ensure proper deck orientation, perform
the following steps: (1) Move the mower onto a flat surface
such as a concrete pad. (2) Ensure all tires are inflated to
the recommended pressure. (3) Measure the distance from
the ground surface to the bottom of the blade enclosure (as
indicated in the photograph) at each of the four corners.
The rear corners should be equal in ground clearance as
should the forward corners. The forward corners should be
approximately 1/8” lower than the rear corners. If adjustment becomes necessary, perform
the actions described below in order to return the mower to its optimum cutting state. The
deck brackets (pictured, 4 total) are the principal means for deck reorientation. Begin the
adjustment by leveling the deck; both front to back and left to right. This is accomplished by
shifting the position (upward/downward) of the deck brackets within the vertical slots located
on their respective deck tabs. Once the deck is parallel with ground, the proper forward tilt
must be obtained. This can be achieved by re-adjusting the forward or rearward deck bracket
pair. If necessary, the two turnbuckles may be used for slight position refinements.
PAGE 23