17
TROUBLESHOOTING HELP
•
No water is exiting the Nucleation Nozzle
(The most common
reason that no water would exit the nucleation nozzle is because the
nozzle in the snow gun is frozen. If the air hose was connected before
the water feed was turned on, freezing can occur. This can also occur
if water was left in the snow gun and froze during setup)
SOLUTION:
Take the snow gun indoors to thaw. Run the snow
gun under warm water if necessary. If freezing occurs, it is likely in the
small fitting directly below the snow gun head inside of the aluminum
housing. Run warm water over the bottom of the snow gun head near
the top of the housing.
Make sure no water is left in the snow gun after use. Use the HP Blow
Out Tool to remove all water from the snow gun after each session.
Store indoors in a warm, dry location. Bring the snow gun outside only
when you are ready to turn the water on to minimize the snow guns
exposure to cold temperatures.
MAKING ICE
(or low-quality snow)
CONTINUED
