![background image](http://html1.mh-extra.com/html/backyard-discovery/next-generation-5007/next-generation-5007_assembly-manual_3385846035.webp)
STEP 48
Stand Entry Ladder up and line up Ladder Rails
with pre-drilled holes and H12 Floor Rail and
using 3/16” drill bit pilot hole Entry Ladder Rails.
Then fasten ladder assembly using 2-1/2” Lag
Screws, Internal Tooth Lock Washers and Flat
Washers through H12 Floor Rail into Entry Ladder
Rails.
At this point, attach Y31 metal grip to ladder rails.
Measure down 4” from top edge and drill a pilot
hole in center of the board with 3/16” drill bit.
Attach handles at these points using 2 ½” lag
screw, lock washer and flat washer. Now use hole
in bottom of handle as guide to pilot drill and finish
attaching with 2 ½” lag screw, lock washer and
flat washer.
STEP 49
Measure up 5-1/4” from H12 Floor Rails and
mark center of C1 and C3 Posts. Pilot drill using
3/16” drill bit. Now Attach Y30 Metal Hand Grips
to each Post with 5/16 x 2-1/2” Lag Screws,
Internal Tooth Lock Washers and Flat Washers.
Using hole in Y30 Hand Grip in top as guide, pilot
drill and finish attaching with 2-1/2” Lag Screws,
Internal Tooth Lock Washers and Flat Washers.
C1
Y30
Y30
C3
SHORT METAL HAND GRIP
2 REQUIRED
Y30
5/16 X 2-1/2"
LAG
SCREW
5/16"
INTERNAL
TOOTH
LOCK
WASHER
5/16" FLAT
WASHER
Y31
35"
METAL GRIP
2 REQUIRED
© Leisure Time Products Inc.
Next Generation 5007 10-0409 Version 4
5 1/4"
Page 32
Y31
Y31
E1
E1
H12
4"
Meijer.com
Содержание Next Generation 5007
Страница 3: ...Meijer com...