14
control knob in for 10 to 15 seconds. Release the control knob. The control
knob should pop back out and then remain lit.
Note: If the fire does not light, turn the knob to the “OFF” position and wait five
(5) minutes before trying again.
3. To turn down the flame, push the control knob in slightly and turn to Medium
(medium
or Low (small flame).
4. To shut down the fire pit, turn the control knob to the “OFF” position and turn
off the tank valve.
BATTERIES
Make sure the control knob is in the "OFF" position.
Unscrew the push button cap on the ignition module
located on the control panel to access the battery
compartment. The ignition module requires one Alkaline
AAA size battery (1.5V). The negative (-) end goes in
first. See Figure 17. Dispose of battery safely. May
explode or leak if charged or disposed of in fire. Make
sure of the polarity. Mercury and cadmium free
Always purchase the correct size and grade of battery most suitable for the
intended use. Replace all batteries of a set at the same time. Clean the battery
contacts and also those of the device prior to battery installation. Ensure
batteries are installed correctly with regard to polarity (+ and -). Remove
batteries from equipment which is not to be used for an extended period of time.
Remove used batteries promptly.
MAINTENANCE
The flames should look like those in Figure 18. To clean the burner, use a soft
brush after the burner has cooled completely. Never use a vacuum cleaner on
the burner. It is recommended that the fire pit be stored indoors during the winter
if it will be subjected to freezing temperatures. The LP cylinder must be
disconnected and removed from the appliance before the appliance can be
stored indoors.
Figure 17
