Bacharach INJECTOR CALIBRATOR CD3, Инструкция по установке и эксплуатации

Страница: 25 / 96

Instructions 67-9319
Bacharach, Inc.
Page 2-7
INJECTOR CALIBRATOR CD3 INSTALLATION
2.8 Repacking for Shipping
1. Drain the calibration fluid reservoir from both
drain valves.
2. Pack all the accessories listed in Section 5.2. Do
not ship the calibrator with its accessories
hanging on the door.
3. Disconnect all power and utilities. Drain water
and blow out water lines by applying shop air
pressure at the WATER OUT fitting. Plug both
ports.
4. Displace Drive Motor belt so that it is hanging
loose and not engaged on any pulley set.
5. Place 5/8 inch thick wooden blocks under each
end of the drive motor mounting plate.
6. Tighten the main drive motor mounting spring
until the motor is secure.
7. Place 5/8 x 7/8 x 11-1/2 inch wooden blocks
under each side edge of the console.
8. Use a 3/4 inch long, 1/4-20 hex head cap screw
in the center of each edge of the console to hold
the console securely to the cabinet.
9. Install shipping blocks under the flowmeter
transducer.
10. Use two 3/4 inch long, 1/4-20 bolts, nuts and
washers to fasten the flowmeter transducer to
the console.
11. Do not drain the fluid from the cambox.
12. Bolt the calibrator to a shipping skid.
13. Pack the calibrator in a sturdy container for
shipping.
2.9 Shipping and Storage
1. Make sure the calibrator is kept upright during
shipping and storage.
2. Do not drop or stack calibrators.
3. Store in a temperature and humidity controlled
environment.