Bacharach INJECTOR CALIBRATOR CD3, Инструкция по установке и эксплуатации

Страница: 19 / 96

Instructions 67-9319
Bacharach, Inc.
Page 2-1
INJECTOR CALIBRATOR CD3 INSTALLATION
Figure 2-1. CD3 Dimensions
Figure 2-2. Spring Tension
Figure 2-3. Shipping Bolts
2.0 INSTALLATION
2.1 Selecting the Site
Select an area where the calibrator will be level and
on solid footing, plus convenient to shop air, cold
water line, drain and electrical supply. Allow space
around the unit for operation and maintenance.
Allow for clearance of the cabinet doors and for easy
removal of panels. If possible, locate the unit away
from heavy vibrations and dusty or dirty
atmosphere.
2.2 Hold Downs
For security in shipment, the main motor, flow-
meter and console are bolted down and the motor
mounting plate spring is completely compressed.
NOTE: The circled numbers shown with
the labels on the photos refer to step num-
bers on the following instructions.
1. Open the left side hinged door and remove the
panel in the rear of the console.
2. At the left side of the calibrator, loosen the top
nuts on the motor mounting plate spring.
3. Remove the two shipping blocks from between
the motor plate and the frame.
4. Adjust the spring tension to 3-3/4 inches.
5. Remove the two shipping spacers between the
transducers base and console base by removing
the two ¼-20, 3/4 long bolts, nuts and washers.
NOTE : Save all removed (shipping)
hardware for possible future moving or
shipment.
6. Remove two shipping (wooden) spacers between
the console and tabletop, located on each side of
the console, by removing the two ¼-20, 3/4 long
bolts and washers.
7. Close the front doors and reinstall the rear
panels.
2 Loosen Spring Nut
4 Adjust Spring to 3¾ in.
5 Remove Transducer Bolt
(typical both sides) 6 Remove Console Bolt
(typical both sides)