Bacharach IAM-100, Инструкция по установке и эксплуатации, Страница: 25 / 36

IAM-100 and Controller Manual
6209-9000 Rev 2 25
Section 6. Functional Tests and Calibration
6.1. Overview
NOTE: The IAM-100 is calibrated at the factory. After
installation, a zero adjustment maybe required due to
differences in environmental conditions.
IMPORTANT: If the IAM-100 is exposed to a large leak it
should be tested to ensure correct functionality, and the
sensor replaced if necessary.
To comply with the requirements of EN378 and the European F-GAS
regulation, sensors must be tested annually. However, local regulations
may specify the nature and frequency of this test. After sensor element
replacement, recalibration of the unit using known concentration of gas is
required.
CAUTION: Check local regulations on calibration or testing
requirements.
IMPORTANT: The testing and/or calibration of the unit must
be carried out by a suitably qualified technician, and must be
done:
•
in accordance with this manual
•
in compliance with locally applicable guidelines and
regulations.
Suitably qualified operators of the unit should be aware of the
regulations and standards set down by the industry/country
for the testing or calibration of this unit. This manual is only
intended as a guide and, insofar as permitted by law, the
manufacturer accepts no responsibility for the calibration,
testing, or operation of this unit.
The frequency and nature of testing or calibration may be
determined by local regulation or standards.
EN378 and the F-GAS Regulation require an annual check in
accordance with the manufacturer’s recommendation.