9. Remove the discharge accessory from the skid. Lift the discharge accessory and position it over the unit so
that the flanges of the section are about 50 mm above the unit. Dot not let the section swing and damage the
sealer.
Use at least four drift pins (see figure) in the fastening holes located on the long sides of the sections to align
the discharge accessory to the unit. To avoid incorrect alignment, refer to the below drawing for the position of
the fastening holes to be used. Use additional drift pins in the middle of the unit if required, to align long panels.
(See figure "Usage of drift pin to align the screw holes")
Make sure all holes from the discharge accessory and the unit are properly aligned before lowering the
discharge accessory completely to the unit.
Position of the fastening holes to be used.
1.
Drift pin position
2.
The distance between the fastening hole in which the drift pin is inserted and the corner should be at least 30cm
3.
Usage of additional drift pin for long sides
4.
Fastening hole
Usage of drift pin to align the screw holes
10. Using the self-tapping screws, drive screws down through the middle section and into the lower section. Start
next to lifting ear towards centre of unit. Continue to install the screws using the drift pin to align the screw
holes until all holes are filled with screws
CAUTION
Make sure coupling is installed on external piping if delivered with the dry coil.
W W W . B A L T I M O R E A I R C O I L . E U
15
3 Optional accessories assembly
3 Optional accessories assembly
