TrilliumSeries™ Adiabatic
Cooler - TRF Rigging & Assembly Instructions
–
Rigging
Page | 6
2. Rigging
Adequate precautions appropriate for the installation and location of these products should be taken to safeguard the
equipment and the premises from damage, and the public from possible injury.
The procedures listed in this manual must be
thoroughly reviewed prior to rigging and assembly. Read all warnings, cautions and notes
.
DANGER
: All electrical, mechanical, and rotating machinery are potential hazards, particularly
for those not familiar with their design, construction, and operation. Accordingly, use appropriate
lockout procedures. Do not perform any service on or near the fans, motors, and drives, without
first ensuring that the fans are disconnected, locked out, and tagged out. Adequate safeguards
(including the use of protective enclosures where necessary) should be taken with this
equipment both to safeguard the public from injury and to prevent damage to the equipment, its
associated system, and the premises.
Shipping
BAC TrilliumSeries
™
adiabatic coolers are factory assembled to ensure uniform quality with minimum field assembly. For each
unit only one lift is required. Contact your local
for more information. For the dimensions and weights of a
specific unit or section, refer to the submittal drawings.
Pre-Rigging Checks
When the unit is delivered to the jobsite, it should be checked thoroughly to ensure all required items have been received and
are free of any shipping damage prior to signing the bill of lading.
DANGER:
Failure to use designated lifting points can result in a dropped load causing severe
injury, death, and/or property damage. Lifts must be performed by qualified riggers following
BAC published Rigging Instructions and generally accepted lifting practices. The use of
supplemental safety slings may also be required if the lift circumstances warrant its use, as
determined by the rigging contractor.
WARNING:
To prevent severe injury or death the top horizontal surface of the unit is not
intended to be used as a walking surface or working platform. If access to the top of the unit is
desired, the purchaser/end-user is cautioned to use appropriate means complying with
applicable safety standards of governmental authorities.