BAC S1500E, Инструкции по монтажу и установке

Страница: 16 / 28

W W W . B A L T I M O R E A I R C O I L . E U
SECTION ASSEMBLY
Method for Two-Piece Cells
1. Position the lower section on the supporting steel and bolt in place.
2. Remove any protective wood from the top horizontal flanges of the lower section. Wipe down the flanges to
remove dust, dirt or moisture that may have accumulated during shipment and storage.
3. Install butyl sealer tape, supplied with the unit, on the mating flanges of the lower section in a continuous line
over the centre line of the tapper holes. At each corner, allow 2 to 3 cm overlap. Do not stretch sealer tape.
4. Sealer applied to the end flanges of a single cell section unit and to the end and centre flanges of two cell units
must be continuous.
Installation of tape sealer
1. Bolt M10
2. Flat tape sealer laid over punch line around unit perimeter
3. Flatwasher, lockwasher and nut
4. Section assembly guide
16
S1500E
XES1500E
3
3 Section Assembly
3 Section Assembly