www.implast.com.pl
Folding the chassis
•
To fold the chassis, pull back the two
sliders on either side of the chassis handle
& release the secondary safety catch, gently
let the chassis close (Picture 14).
Using the handle height adjusters; fold the
handle back on itself to make the folded
chassis more compact (Picture 15).
Safety harness
•
Always apply the parking brake before
placing your child in the vehicle.The safety
harness has two shoulder straps, two waist
belts and a crotch strap. Place the two
shoulder straps over the child’s shoulders
and the waist belts around the child’s waist,
the crotch strap should be placed between
the child’s legs. The shoulder straps and
the waist belts should be clipped into
the buckle at the end of the crotch strap
(Picture 16). The harness can be adjusted
to suit your child by sliding the adjusters
along the shoulder straps and waist belts.To
release the safety harness, push the bottons on
the centre buckle. D-rings for attaching a separate
harness conforming to BS 6684 can be found on
either side of the seat frame near the backrest
and seat base hinge.
15.
14.
SAFETY CATCH
Fitting/removal of Britax
car seats to the LUX chassis
(Excludes Twin Classic)
The Lux can be fitted with the following Britax Infant Carriers: Babysure and
Rock -a-Tot Plus SI
•
To attach the car seat adaptor frame to the chassis place the frame so that all four
pins rest in the attachment devices. Push the frame down until the frame clicks and
locks into position. The adaptor frame should be orientated so that the bend in the
adaptor frame is upwards and the thinnest cross bar of the adaptor is closest to the
handle end of the chassis. Rest the car seat on the adaptor and allow the two slots on
the car seat rockers to locate on the thin cross bar. Fasten the locking clip (located at
the rear of the car seat backrest) around the adaptor frame. Check that the adaptor
is securely attached to the chassis and that the car seat is securely attached to the
adaptor before use. Refer to the Britax car seat USER GUIDE for further information
on harness use and fitting the infant carrier into a car. To remove the car seat from
the adaptor; release the clip at the rear of the seat and lift the car seat upwards and
clear of the adaptor frame. The adaptor frame can be removed from the chassis by
following the procedure for removing the seat unit or pram body.
16.
5406_F_Implast_ lux.indd 7
2006-11-22 08:37:36
