BabyOno SENSI, Инструкция по эксплуатации

Страница: 10 / 48

INSTRUCTIONS FOR ASSEMBLY:
1
. Place the silicone massaging pad (1) on the breast pump funnel (2) and press it to form a
whole.
2 . Combine the assembled main body (6) with the funnel element of the pump (2) and check
whether it is correctly attached.
3 . Attach the silicone pipe (7) with one end to the top part of the main body (6a) and with the
other end to the silicone pipe inlet (15a) at the back of the pump.
4. Make sure you do not lose the small release valve (9) since in case it is missing the pump
will lose the suction function.
5 . Attach the seal (3) and silicone check valve (4) to the funnel and next combine the bottle (5)
with the breast pump funnel (2). The breast pump is suitable for standard bottle sizes.
6 . The use of the adaptor (13) allows combining the breast pump with wide neck bottles.
7. Put the assembled breast pump into the base (8).
8 . Connect the mains power lead (14) to the back input of the pump (15b) and plug into an
electrical wall socket (DC 3V). Note! Use only an original mains power lead! Other mains
power leads may damage the product and may be dangerous in use.
INSTALLING BATTERIES:
1
. Press and remove the battery compartment cover at the bottom of the pump.
2 . Insert 4 1.5 V batteries (alkaline batteries required). Pay attention to correct positioning of
“+” and “-“ battery ends. It is marked inside the battery compartment.
3 . Close the battery compartment by pressing the cover.
4 . Remove the batteries if the device is not to be used for a longer period of time or if it is
mains powered.
INSTRUCTIONS FOR USE:
1.
Remember that stress has a considerable in fl uence and impact on the amount of produced
milk. Before you start expressing milk make sure to eliminate any situations stressful to you.
Try to relax and always remember about hygiene: wash your hands with soap and water and
your breast with water only.
2 . Many women feel more thirsty during breastfeeding or expressing of milk – prepare a glass
of water or anything else to drink in order not to stop expressing milk.
3 . Do not be discouraged with the initial failures – you will shortly become skilled and
expressing of milk will not pose a problem to you.
4 . Sit down in a position comfortable to you that will enable you to lean slightly forward.
5. Take the previously disinfected breast pump (make sure that all the elements are correctly
assembled). Place the breast inside the pump main body adjusting it to the silicone pad in
order to place a nipple deep enough to provide its proper stimulation by petals on the pad.
6 . Press the power button (15c) for 2 seconds till a corresponding diode on the pump is on.
7. Next choose a proper program for the breast pump operation by pressing the T1/T2 button
(15c):