www.babylove.com.au
www.babylove.com.au
A
.
The seat needs to be attached to the seat moulding. There
are 3 attachment points at the front and 6 around the top
section.
B.
Position the seat into the seat moulding.
C.
Attach the seat to the front section first. Locate the plastic
pins into the keyholes and slide down until locked into
position. Pull down by the fabric if a little tight to make sure
all 3 plastic pins are securely locked.
D.
To attach the top seat section to the seat moulding. Align the
square hole in the seat fabric over the square hole in the seat
moulding.
Now locate the plastic clip attached to the backrest support
and press it through the holes until it locks into the seat
moulding.
Now continue to insert the remaining clips into and around
the rear of the seat moulding.
Pull up on the fabric seat to make sure all the clips are
engaged. If not press them until locked into position.
SEAT ASSEMBLY
08
05
NOTE: The child must be removed from the walker
before releasing the lock to lower the walker, to avoid
injury. Be sure to follow these instructions carefully to
avoid the top tray falling down onto your hand.
A.
Remove the child from the walker.
B.
Locate the safety lock button underneath the tray.
C.
Place one hand on the base. Turn the safety lock button
anti clockwise. Now push up on the front of the button so
it rotates upward. Hold the button in this position and
lower the seat down.
6. CLOSE/LOWER AND ADJUST WALKER HEIGHT
B.
To adjust the seat height from highest to lowest of
three positions :
D.
Before completely lowering down, take care of your hand
position and make sure you have enough space.
D.
A.
Remove the child from the walker.
B.
Position one hand on the safety lock button located
underneath and centre of tray and the other hand on
either corner of the tray.
C.
Turn the safety lock button anti clockwise and slowly
push and hold the button up and the tray will begin
to lower. Let go of the lock and allow the the tray to
lock into a lower position. Press down lightly on the
upper tray to confirm it is locked into place.
B.
C2.
C1.
C2.
D4.
D3.
C1.
D2.
D1.
A.
